Lithonia Lighting 3950 BN U Guía de instalación descargar pdf (Pagina 4)

page 4

1. Remove fixture components and parts pack(s). Check

that all parts are included. See Figure 1.

Disassemble the fixture by unscrewing the three finial caps

and removing the “L” angles, metal ring and diffuser.

3. Attach crossbar to junction box with the (2) #8 x 1 machine

screws. (head of green screw should face downward.)

Screw the 1/8IP x 1½" nipple into the center hole of the

crossbar about ¼ inch. See Figure 3.

WIRING AND FIXTURE OPERATION

CAUTION: Connect fixture to supply wires rated for at

least 90° (194°F). Do not use fixture on dimming cir-

cuits.

FIGURE 2: TO FLUSH MOUNT FIXTURE

Follow steps 5A à 7A.

5A. With the power off, connect the copper ground wire from

the junction box to the fixture by wrapping it under the head

of the green ground screw and tightening the screw. (If house

wiring includes no ground wire consult your local electrical

code for approved methods). See Figure 3.

6A. Use wirenuts to connect the black fixture wire(s) to the

black power supply wire and white fixture wire(s) to white

power supply wire. See Figure 3 .

FOR PROPER CONNECTION, PLACE WIRENUT OVER

WIRES, TWIST CLOCKWISE UNTIL TIGHT.

7A. Place the fixture pan over the nipple extending from the

crossbar previously mounted to the junction box.

See Figure 3.

8A. Place a lock washer and hexut onto nipple. Hold the pan

against the ceiling and tighten the nut until the pan is secure.

Proceed to Step 12.

Figure 2

Figure 3

1 2 3 4 5 6 7 8

Sin comentarios

Lithonia Lighting 3950 BN U Guía de instalación Pagina 4