Lithonia Lighting IB 632 MVH Guía de instalación descargar pdf (Pagina 3)

I-BEAM

Installation Instructions

Lithonia Lighting

INDUSTRIAL VALUE STREAM

One Lithonia Way, Conyers, GA 30012

Phone: 800-315-4963 Fax: 770-981-8141

www.lithonia.com

Part Number: U21293

Revision Date: 10/2007

INSTALLING BATTERY PACK SUPPLIED WITH THE FIXTURE

NOTE: BATTERY PACKS SUPPLIED WITH 6 LAMP T5 LAMPS WILL NOT BE INSTALLED IN THE

FIXTURE. THE BATTERY IS EXTERNALLY MOUNTED ON THE BACK SIDE OF THE CHANNEL.

Battery unit comes with Pilot light / Test Switch connector disconnected to prevent shock and

battery discharge.

1. Plug positive end of battery wiring harness to positive end of fixture wiring harness. Harness is accessible through the

open hole on the back of the fixture.

2. Plug pilot light / test switch into battery.

3. Verify battery operation by engaging pilot light / test switch. If wired correctly, 1 lamp will illuminate.

Keeping battery in the battery box, secure box to back of channel with the 4 screws provided. Do not over tighten. Over

tightening will cause stripping and void all warranties.

1 2 3 4

Sin comentarios

Lithonia Lighting IB 632 MVH Guía de instalación Pagina 3